john deere oil gallery plug removal
Moderator: Team
-
- Member
- Posts: 94
- Joined: Thu Jun 14, 2007 9:30 pm
- Location: Lebanon,Ky
john deere oil gallery plug removal
anybody here can tell me how to remove the ball type plugs in the oil galleries on a john deere engine without putting this thing on a mill and cutting them out?
-
- HotPass
- Posts: 9406
- Joined: Tue Nov 22, 2005 5:41 am
- Location:
Re: john deere oil gallery plug removal
https://www.semasan.com/breaking-news-archives?utm_campaign=DrivingForce_DF272&utm_content=SeeAllLeg
-
- Member
- Posts: 94
- Joined: Thu Jun 14, 2007 9:30 pm
- Location: Lebanon,Ky
Re: john deere oil gallery plug removal
thanks ,already read that but these are too deep to weld on and am afraid i will burr up the hole and make a mess.
-
- Expert
- Posts: 537
- Joined: Mon Dec 12, 2016 3:37 pm
- Location:
Re: john deere oil gallery plug removal
If you have access to an oxy actetlyne set you can use a normal welding tip not too large,and get the ball to just start to pool then snap the acetylene off and burn thru the ball with the oxygen. Works like a a cutting torch. If you dont have the ball hot enough (metal pooling) nothing will happen . I have used this method removing the ball bearings on toyota cast iron diesel heads and it works a treat.