Intake weld & grind project
Posted: Tue Feb 11, 2020 7:41 pm
Updating a manifold, after testing with the 4150 flange & moderate porting to determine if we were in the ballpark it was time to break out the TIG & fix some deficiencies for the application.
There is a manifold available for the motor (holden v8) in a dominator style, but the runner entires & runner volumes are too big for this engine, so it was either do a bunch of filling on one of them or make the smaller manifold work.
Starting point, Torque power pro paw intake, 4150 flange:
20200203_114619 by tony knight, on Flickr
20200203_114624 by tony knight, on Flickr
Welding:
20200203_135255 by tony knight, on Flickr
20200203_171240 by tony knight, on Flickr
On to the mill:
20200211_110445 by tony knight, on Flickr
20200211_120315 by tony knight, on Flickr
Stud holes & marking out:
20200211_130516 by tony knight, on Flickr
20200211_131137 by tony knight, on Flickr
And quite a few hours of grinder time:
20200212_100433 by tony knight, on Flickr
20200212_100437 by tony knight, on Flickr
20200212_100455 by tony knight, on Flickr
20200212_100504 by tony knight, on Flickr
20200212_100514 by tony knight, on Flickr
Now we have a 4500 manifold with appropriately sized runner entries, much closer to even runner volumes, end runners exposed to plenum etc etc.
There is a manifold available for the motor (holden v8) in a dominator style, but the runner entires & runner volumes are too big for this engine, so it was either do a bunch of filling on one of them or make the smaller manifold work.
Starting point, Torque power pro paw intake, 4150 flange:
20200203_114619 by tony knight, on Flickr
20200203_114624 by tony knight, on Flickr
Welding:
20200203_135255 by tony knight, on Flickr
20200203_171240 by tony knight, on Flickr
On to the mill:
20200211_110445 by tony knight, on Flickr
20200211_120315 by tony knight, on Flickr
Stud holes & marking out:
20200211_130516 by tony knight, on Flickr
20200211_131137 by tony knight, on Flickr
And quite a few hours of grinder time:
20200212_100433 by tony knight, on Flickr
20200212_100437 by tony knight, on Flickr
20200212_100455 by tony knight, on Flickr
20200212_100504 by tony knight, on Flickr
20200212_100514 by tony knight, on Flickr
Now we have a 4500 manifold with appropriately sized runner entries, much closer to even runner volumes, end runners exposed to plenum etc etc.