Olds 350
Moderator: Team
-
- Pro
- Posts: 331
- Joined: Fri Jun 20, 2014 8:41 am
- Location:
Re: Olds 350
I’ve gone as close as .031”/032” with very loose rod and pin clearances with factory rods....7k max
No contact
No contact
-
- Guru
- Posts: 6381
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: Olds 350
IF you have cast pistons having about .0015" skirt clearance it will probably clear.rocketracer380 wrote: ↑Tue Aug 18, 2020 6:38 pm Is .027 too tight for piston to head clearence with a steel rod?
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.