can this make 520 hp?
Moderator: Team
Re: can this make 520 hp?
Is that with an unmodified Air Gap? Any carb spacer used?
What were the final cam specs?
Hope you don't mind the barrage of questions.
This may provide even more insight for another SBC that's in the works.
Thanks.
Kevin
Re: can this make 520 hp?
Is that with an unmodified Air Gap? Any carb spacer used?
What were the final cam specs?
Hope you don't mind the barrage of questions.
This may provide even more insight for another SBC that's in the works.
Thanks.
The manifold was port matched which probably did nothing.
The cam : 233/236 @ .050, .583/.562, 109 in at 105
Sorry I forgot, it had a 1 inch open spacer for all the pulls because that's the way it will be in the car..
What were the final cam specs?
Hope you don't mind the barrage of questions.
This may provide even more insight for another SBC that's in the works.
Thanks.
The manifold was port matched which probably did nothing.
The cam : 233/236 @ .050, .583/.562, 109 in at 105
Sorry I forgot, it had a 1 inch open spacer for all the pulls because that's the way it will be in the car..
Re: can this make 520 hp?
It was done at 6100 and then was almost perfectly flat until 6400 where we had been stopping the pulls.