427 Build And Drag Test

General engine tech -- Drag Racing to Circle Track

Moderator: Team

novadude
Guru
Guru
Posts: 1500
Joined: Thu Oct 11, 2007 3:24 pm
Location: Shippensburg, PA

Re: 427 Build And Drag Test

Post by novadude »

maxracesoftware wrote: Wed Jan 13, 2021 12:27 pm

i like the QJet tricks in VortecPro's post here :
the Q-Jet on the right-side :
viewtopic.php?p=885216#p885216

Yeah... I was diggin' the adjustable bleeds too.
vortecpro
Guru
Guru
Posts: 1767
Joined: Fri Apr 24, 2009 11:10 pm
Location:

Re: 427 Build And Drag Test

Post by vortecpro »

Ready to race-smooth idle 427.
You do not have the required permissions to view the files attached to this post.
Racing a NA NHRA stocker should be mandatory before any posting.
cpmotors
Expert
Expert
Posts: 986
Joined: Fri Feb 15, 2008 8:22 pm
Location: Janesville,Wi
Contact:

Re: 427 Build And Drag Test

Post by cpmotors »

vortecpro wrote: Sat Jan 23, 2021 9:51 pm Ready to race-smooth idle 427.
Always a nice clean look in your car Mark. Accumulator is gone and hadn't noticed you don't run an alternator either? Same gear and converter as in your PP 467 testing? Converter flashed 5k or so before didn't it?
Pete Graves
CPMotorworks,Inc.
Custom Engine Machining
Cylinder Head Fixture for Vertical / Surfacing Mills since 2008
vortecpro
Guru
Guru
Posts: 1767
Joined: Fri Apr 24, 2009 11:10 pm
Location:

Re: 427 Build And Drag Test

Post by vortecpro »

The converter has been changed, same gears, will run in high altitude first then makes some changes and go down low.
Racing a NA NHRA stocker should be mandatory before any posting.
Post Reply