Can y'all help with finding harmonic balancer .
Fits 1964-67. It's 63/4 diameter.
This one has the timing mark inline with the keyway.
Most are 10° offset.
This is for restoration project to keep the original timing tab.
Thanks for input.
327 balancer info
Moderator: Team
-
- Guru
- Posts: 4607
- Joined: Sun Sep 18, 2011 11:31 am
- Location: Heading for a bang up with Andromeda as we all are.
Re: 327 balancer info
If yours is not cracked then just send it out to the Damper Doctor and it will come back rebuilt and better then new!
You can cut a man's tongue from his mouth, but that does not mean he’s a liar, it just shows that you fear the truth he might speak about you!
-
- Guru
- Posts: 6389
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: 327 balancer info
Just put you own TDC mark on a new one where it needs to be.
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.
Re: 327 balancer info
my understanding is:
68 & back sbc Damper has its timing groove located 2* advanced from keyway.
69 & up sbc Damper has its timing groove located 10* advanced from keyway.
see Pioneer damper pn DA3270-HD
6.12" outer ring OD
4.63 pounds weight
perhaps your damper ring has slipped (from +2* to +10*) ...Dunno ? OR ... it hasn't slipped but yours also has a later timing cover-tab ... Dunno ?
pioneer's HD dampers have Vulcanized rubber versus standard's rubber is simply stuffed.
Because of their light weight & small OD, I (& many others) used to run little 327 dampers on 350+ CT motors; we made our own pointer-tabs anyway.
68 & back sbc Damper has its timing groove located 2* advanced from keyway.
69 & up sbc Damper has its timing groove located 10* advanced from keyway.
see Pioneer damper pn DA3270-HD
6.12" outer ring OD
4.63 pounds weight
perhaps your damper ring has slipped (from +2* to +10*) ...Dunno ? OR ... it hasn't slipped but yours also has a later timing cover-tab ... Dunno ?
pioneer's HD dampers have Vulcanized rubber versus standard's rubber is simply stuffed.
Because of their light weight & small OD, I (& many others) used to run little 327 dampers on 350+ CT motors; we made our own pointer-tabs anyway.