Seat cutter for 40 degree exhaust
Moderator: Team
Seat cutter for 40 degree exhaust
I'm doing a valve job on a set of 5.2 ford voodoo heads and just found that the exhaust seat is 40 degree. Does anyone have a part number for a cutter bit that will work on these seats?
-
- Guru
- Posts: 6390
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: Seat cutter for 40 degree exhaust
37.5 is all I can know about, near that angle.
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.
-
- Guru
- Posts: 4162
- Joined: Sun Jan 29, 2006 9:46 pm
- Location: Lund in Sweden
- Contact:
-
- Pro
- Posts: 449
- Joined: Tue Aug 09, 2022 9:20 am
- Location: US
Re: Seat cutter for 40 degree exhaust
This, that's what I would do
Maximum power using simple logic and common sense
Re: Seat cutter for 40 degree exhaust
If you send them a drawing, Serdi and Goodson will make a cutter bit for you. I expect that Newen will too.
Jim McMahon
Heads1st
http://www.heads1st.com/
Heads1st
http://www.heads1st.com/