Steel tube 15CDV6 1.7734.5 to source

Tech questions that don't fit above forums

Moderator: Team

Post Reply
german4inline
Member
Member
Posts: 180
Joined: Tue May 20, 2014 5:09 pm
Location:

Steel tube 15CDV6 1.7734.5 to source

Post by german4inline »

Guys,
I´m desperately looking for a small quantity of steel tube 15CDV6, well suitable to make pushrods ( at least for my classic french race engine), does anyone know where to source? Here over in Germany it´s quite impossible to get these small quantities. I need OD 8 mm (0,315") and 1mm wall thickness (0,039") It should be the tempered quality (tensile str. 1080 N/mm2). I need at least 1 meter, better 2.
If anyone could recommend another suitable material ( maybe from a pushrod manfacturer) it would strongly appreciated. The ID has to be very close to my size because I have end pieces to be pressed in. Thanks for help.
Racer71
Pro
Pro
Posts: 324
Joined: Mon Jun 24, 2019 12:36 pm
Location:

Re: Steel tube 15CDV6 1.7734.5 to source

Post by Racer71 »

Check with Manton pushrods they sell kits do you can build to length.
Post Reply