JKM Flow Bench

[liqu]

Hi guys, I have a JKM600 flow bench that I just can't figure out what to do, I got a vacuum hose diagram off the internet and it looked like mine were installed wrong so I changed them to match the diagram, no luck, I think I just made it worst, can anyone that can help?

[ClassAct]

Hi guys, I have a JKM600 flow bench that I just can't figure out what to do, I got a vacuum hose diagram off the internet and it looked like mine were installed wrong so I changed them to match the diagram, no luck, I think I just made it worst, can anyone that can help?

@fastvette PM him and see if he can help you. I had a JKM bench. Should have never sold it.

What issue(s) are you having?

[liqu]

I bought it and have never been able to make it work, I think I need a walk through of how to use it and what to look for.

[SupStk]

I have a JKM 600. If you aren't in big hurry, I can pull mine apart and draw a schematic.

You may have a bad piece of tubing. The surgical tube Jerry used is prone to crack and split. Replaced some of it with clear plastic hose.

[liqu]

Hi, that would help ALOT, I can figure it out if I know that the setup I have is correct.

Thanks Cliff

[fastvette]

I sold mine years ago to Jmark. He might still have it.

[SupStk]

image.jpg

Hope you can decipher the crappy drawing of the hose schematic on the JKM flowbench.

When testing exhaust flow the switches are up and down for intake test

[liqu]

Thank You, I going to compare that with mine.