Any interest in a winona PH2000 with some tooling? includes basic tooling such as drivers, drill chuck, fixed size counterbore cutters, some pilots, 2 types of head clamps, 3 phase machine.... asking $1000 b.o. located in massachusetts.
Also, any interst in an IDL machine? nice for the hobbyist because it is so simple, and 115v. includes holddown hardware, head stands, some drill/ream bushings, works great, asking $600 b.o
K-line rod heater, aka thermo-fit pin furnace, works great 115v, asking $250
K-line valve guide knurl and ream kit includes speed reducer, asking $100
photos available on request
Seat and guide machine (s) and stuff
Moderator: Team
- nickmckinney
- Guru
- Posts: 1417
- Joined: Fri Aug 01, 2008 11:21 pm
- Location: Orlando
- Contact:
Re: Seat and guide machine (s) and stuff
What part of Mass are you in? I have a friend in Adams? on the west side of the state that might be interested.
Re: Seat and guide machine (s) and stuff
The IDL, do you have a modle number for it? Is this like a table top machine?
I would like to see a picture of it if you have one.
k_starautomotive@yahoo.com.
Keith
I would like to see a picture of it if you have one.
k_starautomotive@yahoo.com.
Keith
“If I hit you with this you’re going to be numb, that’s why they call them numb-chucks “Si Robertson
-
- Guru
- Posts: 1904
- Joined: Mon Jul 26, 2004 10:47 am
- Location: Dubois, Wy.
Re: Seat and guide machine (s) and stuff
I'm interested in either the Winona or the IDL. Where about's in Ma you located?
Re: Seat and guide machine (s) and stuff
I am in methuen, ma which is north east bordering nh. the IDL is a 550, the bigger version. IDL made a little machine as well with a flat metal table, this is the cast iron base table. i will try to get some pics friday and post them.
-
- Guru
- Posts: 1904
- Joined: Mon Jul 26, 2004 10:47 am
- Location: Dubois, Wy.