Sorry, I couldn't find it either. I will let John know about this thread. Thanks, Charlie
bridgeport valve seat options / recomdations tooling
Moderator: Team
Re: bridgeport valve seat options / recomdations tooling
Servedio Cylinder Head Development
631-816-4911
9:00am - 9:00pm EST
631-816-4911
9:00am - 9:00pm EST
-
- HotPass
- Posts: 369
- Joined: Sat Feb 09, 2013 4:22 pm
- Location: North Carolina
- Contact:
Re: bridgeport valve seat options / recomdations tooling
Sorry I haven't been on here a lot.
I have a complete kit to turn your mill into a seat and guide machine. Most efficient one out there and very friendly. Fast and simple to go from milling to head work or resurfacing etc
Contact me at 518-915-3205 or rbjracing1@gmail.com
John
I have a complete kit to turn your mill into a seat and guide machine. Most efficient one out there and very friendly. Fast and simple to go from milling to head work or resurfacing etc
Contact me at 518-915-3205 or rbjracing1@gmail.com
John
-
- Guru
- Posts: 8707
- Joined: Sun Jan 21, 2007 1:16 pm
- Location: Victoria BC Canada
Re: bridgeport valve seat options / recomdations tooling
They suck to get a real nice valve job with. Too many tiny pieces to use and just about all they are good for is doing a half assed job.gunt wrote: ↑Mon Apr 01, 2019 6:25 am And whats the general view on these , apart from the clamping on the valve stem
http://www.newaytoolsales.com/refacers.htm
Any one that tries to do custom head work that uses that system is just wasting their time and money when there
is better tooling available.
Sorry for the rant but I was one of those that wasted time and money many years ago when the new way stuff 1st came out
and while I did get the complete set up I may have used it 5-6 times and was not happy with the results at all and sold it all at a loss and got a new machine and related tooling to get the jobs done right.
Real Race Cars Don't Have Doors
Re: bridgeport valve seat options / recomdations tooling
that was my thoughts , but mixed up the names and was scratching my head trying to figure out why this would be recommended , as i used this system 20yrs ago in training , and that's why i asked here as i dont have the funds to waste the money would be better spent else where .
Cheers
Cheers
Re: bridgeport valve seat options / recomdations tooling
Look at Pete Graves CPmotorworks head fixture, and get the goodson 3D fastcut setup and you will be in business!!
Re: bridgeport valve seat options / recomdations tooling
any advice welcome ,
on 4 valve heads , and starting from fresh with not a clue on where to start any recommendations on cutters to buy from the NEWEN catalog would be greatly appreciated , or advice on angle dimensions sizes , cheers
on 4 valve heads , and starting from fresh with not a clue on where to start any recommendations on cutters to buy from the NEWEN catalog would be greatly appreciated , or advice on angle dimensions sizes , cheers