Sunnen Dial Bore gauge

[ProPower engines]

Hey guys
Looking for the common length of Sunnen Bore gauge for a stand by when my others are getting tuned up.
I try to send them in for correction at least 1 time a year and hate not having a pair on hand for builds and need to always
reset after changing sizes.
The gauge I would prefer is the one that reads in 10th's not 1/2 thou. graduations.
I have all the extensions and setting fixtures just looking for another gauge.
I should mention there is several I seen on E Bay but the wrong graduations just in .0005" not .0001 increments

Any leads will be greatly appreciated.
Dave

[superpursuit]

Dave.
There is a new listing on ebay now for Sunnen bore gauge 2 - 6.125", .0001" graduations, 12" depth. $550.00.

Seller lists it as refurbished.

Good luck.
Allan.

[ProPower engines]

Thanks Allan
I will check it out.

[superpursuit]

Dave. There is a new looking retractable .0001" gauge coming up for auction on November 12 . It looks good in the photo.

Here is a link for it.

https://www.bidspotter.com/en-us/auctio ... f00189ae87

Hope this helps.

Allan.

[ProPower engines]

Thanks again for the lead.
I was about to order a new one but will wait till this goes through

[jimmyhemi]

Where can get a replacement dial guage for a sunnen 2 to 6" dial bore guage

[ProPower engines]

If you call sunnen directly they are very inexpensive about $190.00 for a complete replacement dial indicator
with 1/10th incremental reading.
They had the dial indicators in stock shipped same day. Face colour will differ from your original bore gauge colour
as the back face is white not the older greening colour.