LS3 Carbed build
Moderator: Team
Re: LS3 Carbed build
Please Note!
THE ABOVE POST IN NO WAY REFLECTS THE VIEWS OF SPEED TALK OR IT'S MEMBERS AND SHOULD BE VIEWED AS ENTERTAINMENT ONLY...Thanks, The Management!
THE ABOVE POST IN NO WAY REFLECTS THE VIEWS OF SPEED TALK OR IT'S MEMBERS AND SHOULD BE VIEWED AS ENTERTAINMENT ONLY...Thanks, The Management!
Re: LS3 Carbed build
I put it on last night, got it all hooked up, fired it, loaded it some...that's about all so far. I will be pulling it tomorrow and maybe into next week depending on how well it goes or who else may need to get on the dyno.
We will see.
Re: LS3 Carbed build
A million 9?
Not sure where he ended up on total combination but I am guessing more than 600 hp.
Please Note!
THE ABOVE POST IN NO WAY REFLECTS THE VIEWS OF SPEED TALK OR IT'S MEMBERS AND SHOULD BE VIEWED AS ENTERTAINMENT ONLY...Thanks, The Management!
THE ABOVE POST IN NO WAY REFLECTS THE VIEWS OF SPEED TALK OR IT'S MEMBERS AND SHOULD BE VIEWED AS ENTERTAINMENT ONLY...Thanks, The Management!
-
- Guru
- Posts: 2253
- Joined: Wed Jul 27, 2011 5:22 am
- Location: brisbane AUSTRALIA
Re: LS3 Carbed build
after seeing that stout 408 you did Randy with less compression but Chad has less cubes.
uneducated guess by myself
546 ft/lbs
675 hp @ 6500 rpm
nice build Chad,best of luck on the dyno
steve c
"Pretty don't make power"
"Pretty don't make power"
-
- Guru
- Posts: 2253
- Joined: Wed Jul 27, 2011 5:22 am
- Location: brisbane AUSTRALIA
Re: LS3 Carbed build
that would be impressive and more than likely possible
steve c
"Pretty don't make power"
"Pretty don't make power"
Re: LS3 Carbed build
Your TQ guess is very close.steve cowan wrote: ↑Sat Oct 19, 2019 4:11 pmafter seeing that stout 408 you did Randy with less compression but Chad has less cubes.
uneducated guess by myself
546 ft/lbs
675 hp @ 6500 rpm
nice build Chad,best of luck on the dyno
Randy
-
- Guru
- Posts: 2253
- Joined: Wed Jul 27, 2011 5:22 am
- Location: brisbane AUSTRALIA
Re: LS3 Carbed build
1.44-1.47ft/lbs per cube very impressive
as far as peak hp goes not sure where the engine rpm peak would be with that compression and cam.
going to be a bad ass bracket engine either way
as far as peak hp goes not sure where the engine rpm peak would be with that compression and cam.
going to be a bad ass bracket engine either way
steve c
"Pretty don't make power"
"Pretty don't make power"