-that doesn't seem like very much information to spec (more like speculation) a camshaft...?skinny z wrote: ↑Wed Feb 19, 2020 5:17 pmI'm not trying to reinvent anything mt.
I asked a question about MCA. Seeing as I'm trying to avoid "something that's been done before", I'll continue to ask.
Yes. Good suggestions have risen up. And I check them all out. Funny in that these suggestions often have a different spin. So what's right? What's rubbish? And what fits my unique combination of parts? And before everyone goes off all half-cocked, they're not unique in the sense that no one else has them. But unique in the sense that I have them.
Once all the dots line up, then I'll be good to go.
By the way mt, while you're here I've a question.
How would you spec a cam for the following dyno engine? 383, 9.8:1, 255@.500-.550 iron heads, 6" rods, RPM Air Gap. Pump gas. (I can provide additional details should you want them). I want good on paper results. Forget any application.
-how could anybody make a recommendation without considering application..?