Engine Block Value
Moderator: Team
Engine Block Value
Is there a place on this forum where on might be able to find out the value of an older 350 block ?
Re: Engine Block Value
How high is up?
These days, they're all older, so how old?
Two-bolt or four-bolt?
Standard, .030", .060"?
Two-piece or one-piece rear main seal?
Flat tappet or roller lifter?
Casting number?
Jack Vines
Studebaker-Packard V8 Limited
Obsolete Engineering
Studebaker-Packard V8 Limited
Obsolete Engineering
Re: Engine Block Value
1969 Its the 3932386 casting. 4 bolt mains . It has the 2482 main caps. Its standard bore. I purchased it from the local speed shop. Its been checked for cracks, The bores were sonic tested. Never blown up, no spun bearings etc. Threads are all good. It does not have the DZ suffix.
Re: Engine Block Value
Do you have two posts asking the same question?
Jack Vines
Studebaker-Packard V8 Limited
Obsolete Engineering
Studebaker-Packard V8 Limited
Obsolete Engineering