So you've been running a HFT 230 230 110 .480", .006 numbers are 282 intake 282 exhaust.
Running with wet exhaust, no problems.
If you switch to a hydraulic roller and want similar plus a bit better performance with the extra lift, do you try and maintain the overlap at .006" lift to keep the cylinders dry even though the 50 numbers will most likely be smaller ?
HFT to Hydraulic roller wet exhaust.
Moderator: Team
HFT to Hydraulic roller wet exhaust.
Ignorance leads to confidence more often than knowledge does.
Nah, I'm not leaving myself out of the ignorant brigade....at times.
Nah, I'm not leaving myself out of the ignorant brigade....at times.
Re: HFT to Hydraulic roller wet exhaust.
I would say that if you are in the camp that says overlap is a big player in the cam spec, at least with cams in this range, then personally I would stick with what has worked.
Obviously with the same seat to seat timing, the greater lift is going to mean a faster lobe ( doesn't it?) and as such, the valvetrain has to be up to it
My 2 cents.
Obviously with the same seat to seat timing, the greater lift is going to mean a faster lobe ( doesn't it?) and as such, the valvetrain has to be up to it
My 2 cents.
Kevin
Re: HFT to Hydraulic roller wet exhaust.
If you just want to make more power, but don't want to change the power band RPM, then go to a 282/282@.006"on a 110, but with more lift.
Seat duration is what gets you in trouble with a wet exhaust, not .050" duration.
If you want to keep the torque peak where it is, and have the engine hold the power a little longer, go to a 282/286@.006" on a 111
Seat duration is what gets you in trouble with a wet exhaust, not .050" duration.
If you want to keep the torque peak where it is, and have the engine hold the power a little longer, go to a 282/286@.006" on a 111
Mike Jones
Jones Cam Designs
Denver, NC
jonescams@bellsouth.net
http://www.jonescams.com
Jones Cam Designs' HotPass Vendors Forum: viewforum.php?f=44
(704)489-2449
Jones Cam Designs
Denver, NC
jonescams@bellsouth.net
http://www.jonescams.com
Jones Cam Designs' HotPass Vendors Forum: viewforum.php?f=44
(704)489-2449