Morning. I am new to this forum ! Name is Bob. In Il.
My question is (i am new at engine work!!) putting a c2 327 back together after finding a hyd. Lifter C clip in oil pan! Ouch for sure. I purchased a china oil pump primer tool and noticed when i test fit it to oil pump extension shaft (with oil pump and ext. Shaft installed , oil pan off) , that when i pulled up to remove the tool it pulled the ext. Shaft up and off the oil pump spline ! So i had oil pan off, reached in to put ext. Shaft back in place , then installed oil pan. Now my concern is , what if i put the primer tool in to prime engine and the ext. Shaft raises up off pump, can i get the ext shaft back in place with oil pan installed? Can the ext shaft drop into pan or lodge against some thing or???? Thanks for any help please.
65' sbc 327. Oil pump drive
Moderator: Team
Re: 65' sbc 327. Oil pump drive
Sounds like you don't have the Nylon Oil Pump Driveshaft Locking Sleeve which retains the intermediate shaft to the pump shaft.
-
- Guru
- Posts: 6392
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: 65' sbc 327. Oil pump drive
If that oil pump driveshaft has a metal collar attached around it at the oil pump junction, it may come-up far enough to get disengaged but, will not raise far enough to actually not be in alignment.bobrl wrote: ↑Sat Dec 30, 2023 10:02 am Morning. I am new to this forum ! Name is Bob. In Il.
My question is (i am new at engine work!!) putting a c2 327 back together after finding a hyd. Lifter C clip in oil pan! Ouch for sure. I purchased a china oil pump primer tool and noticed when i test fit it to oil pump extension shaft (with oil pump and ext. Shaft installed , oil pan off) , that when i pulled up to remove the tool it pulled the ext. Shaft up and off the oil pump spline ! So i had oil pan off, reached in to put ext. Shaft back in place , then installed oil pan. Now my concern is , what if i put the primer tool in to prime engine and the ext. Shaft raises up off pump, can i get the ext shaft back in place with oil pan installed? Can the ext shaft drop into pan or lodge against some thing or???? Thanks for any help please.
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.
Re: 65' sbc 327. Oil pump drive
Thanks. So if it comes up off oil pump shaft , i should be able to easily get it back on pump rite? Thanks.
-
- Guru
- Posts: 6392
- Joined: Tue Jul 24, 2012 11:15 am
- Location: Roseville, Michigan (just north of Detroit)
- Contact:
Re: 65' sbc 327. Oil pump drive
If that pump driveshaft has the attached collar, then yes.
http://www.rmcompetition.com
Specialty engine building at its finest.
Specialty engine building at its finest.