Extending intake dividers

[SpeierRacingHeads]

Here is a 300-25 I done for a 350/360hp Super Stock engine. It hated it! Ended up pulling it and grinding it all back out while it was still on the dyno.

Chad, was that with a Q-Jet Carb ???
its very hard to beat the Edelbrock Victor-E Manifold with a Q-Jet

No this was a LT1 combo with a 780 vac sec..

Since they discontinued the E, except the EFI version) I'm thinking I want to design a manifold that is low like the E to fit under the flat hoods.

[SpeierRacingHeads]

Here is a 300-25 I done for a 350/360hp Super Stock engine. It hated it! Ended up pulling it and grinding it all back out while it was still on the dyno.

Chad,did you or were you allowed to use open spacers on this?

Yes we tried several.

[maxracesoftware]

i just by accident found this old Picture
using Epoxy AB Sticks to extend Runner Dividers , they also touch each other
at Plenum Floor

DSC00005_3.JPG

 

[1980RS]

i just by accident found this old Picture
using Epoxy AB Sticks to extend Runner Dividers , they also touch each other
at Plenum Floor

DSC00005_3.JPG

 

Super cool, thanks.